KBWI - primary active runways
KBWI - primary active runways
BWI is my home airport. I know based on the wind direction and speed the primary runways would be takeoff 28 land 33L. Takeoff 15R land 10. After the last update I notice when the winds are at 70 - 80 degrees at 5 knots runway 10 is the active runway and not 15r. It use to be at least be 15R. Is this a MSFS thing?
-
RicardoLVFR
- Site Admin
- Posts: 4503
- Joined: Thu Sep 20, 2018 12:35 am
- Location: Orlando, FL
Re: KBWI - primary active runways
it is definitely an MSFS thing.
If you had KBWI disabled (not installed) would you get the same issue?
If you had KBWI disabled (not installed) would you get the same issue?
Ricardo Morillo
Managing Director/Owner
Managing Director/Owner
Re: KBWI - primary active runways
Yep it is MSFS. Anyway to force to 15R?
Re: KBWI - primary active runways
I posted a similar issue in the MSFS Support area earlier today...sorry, did not see this one. In addition to the OP's comments which are correct, I am seeing 737's use 15L/33R which is the small GA runway. Is there a way to just disable that runway for AI? I just did a scenery rebuild on a smaller airport using the SDK and you can assign runways as primary/secondary or disable them.