Found an elevation issue at LEMD

[Vieira12]

I have reported this issue and many others back in November 4 months on and we still waiting for a patch to sort this issues out same goes out to performance issues it’s horrible performance wise this was my first scenery form you guys and I think it will be the last unfortunately and before everybody says it’s my computer no it’s not I have over 200 airports installed and top computer and only issue I have at the moment it’s this scenery and Cyyz from fly tampa that’s it’s so old and badly optimised as well

[RicardoLVFR]

Hi, we are looking into updating LEMD in the coming weeks. Our apologies for the issues.

[craig_read]

HI,

I also had an issue with elevation.. taxiing off of Runway 18R after landing, I exited via Z7... during the exit the aircraft appeared to drop down as if there was some kind of "invisible hole" it fell into... I was able to continue taxi.. once further down the taxiway... taxi was fine... there is probably a mesh issue here too I think.

Also on approach I noticed that the ILS localizer appears to be slightly off to the left.

Regards

Craig

[RicardoLVFR]

can you try taxiing around the same section again?

[craig_read]

Sorry I have not been on these forums very much. I downloaded the latest version from SimMarket today, v1.1 installed it (I already have v1.1 installed though). I loaded up the PMDG 747 on RWY 18R as per my original scenario, taxied down the runway and exited at Z7. The problem persists (but I think that's obvious because I've made no changes), I can be a bit more precsie for you, it starts to occur on Z7 at the point where the taxiway line separates guiding left on B5 or continuing towards B5 / G13... and continues to be an issue till you're past G13. Does that help you locate it?

Thanks

Craig

[craig_read]

If this helps too, taxiing onto the runway using G7 is no issue.. but taxiing off.. same result every time. The other high speed exists don't have a problem.

[RicardoLVFR]

Ok will look into this, just to confirm this is LEMD for P3d right?

[craig_read]

Yes it is..

[pabloliza]

Hi All
If this one helps too, same issue regarding invisible hole (just northwest area of the airport, T4) and to perform ILS to RWY18R, localizer is not aligned with the runway (if you follow it, you may land left of the runway)
Thanks in advance.

[craig_read]

Just wondering if there is any update on this one?