KFLL Still poor frame rates on final approch with LM P3dv5 HF2.

[rsmith6621ab]

Ricardo,

OK fair enough, LM seem to have fixed the VRAM issue. I did another of my KMSY/KFLL flights where my KMSY takeoff roll FPS are 35-45 with all boxes checked in the config tool using a PMDG 737NG with texture set at 2048 and middle of the road display settings and 70% traffic

However once off the ground I switch to another profile that the average slider is set to less than 40% of its value and the textures set to 1024x1024, Fair weather and traffic settings at 35%. On final my VRAM climbs and stabilizes at 4.6 of 7.1 but my FPS take a dump from 28fps at 2 miles out to 14-16 once I am over shoreline and slowly from there it turns into a slideshow. I have disabled everything in the KFLL config tool and excluded KMIA which is also a LVFR product. My frame rates are locked at 30 in Nvidia control panel and P3d. I am running with the latest Nvidia 451s.... video drivers and the new Win10 version 2004. Oh and BTW I have built a new system with a 9700k CPU OC'd to 5.0 16GBDDR4 3200 Ram and a EVGA Nvidia 2070 Super GPU since my last KFLL post.

I dont seem to have this problem with other LVFR product. I just landed in SCEL with the PMDG 747-8 settings all display setting at least set to 50% and 2048 texture 70% traffic ASp3 weather engine and ASCA, and it was low CIGS and raining hard and it was a smooth approach all the way to the gate, not one single stutter.

I think that KFLL needs to be optimized more for approaches on the 28s. There seems to be something that is bogging the FPS down from the shoreline to to the gate. I dont know if it is the terminal or the slope in the runway. In fact speaking of the slope. Could you create a way for us to just land on a flat runway 10R/28L and see if that is the issue.

KFLL is amazing looking but it is the one of the last airports I want to SIM into.

Thanks for once again hearing me.
Randy

[rsmith6621ab]

Ricardo,

Just an FYI. Just took off out of SCEL same weather conditions but sliders set to 70% Rnwy 35L Traffic 100% with Orbx LC, ASP3 and was able to maintain 50+fps and 3.2 VRAM on takeoff.

[RicardoLVFR]

Hi, you can try landing on 10R/28L without the slope to see if that's the issue.

In reality we beta tested many times and never encountered significant issues. Let me know if you wish to try to disable the sloped runway to see if that's the cause.
Let me know

[rsmith6621ab]

How do I disable the slope?

[RicardoLVFR]

The file FLL_elevrwy.BGL is the sloped runway, so rename it to FLL_elevrwy.BGX
let me know

[rsmith6621ab]

Ricardo.

Excluded the slope flew in with the FSLabs 320. FPS was fine (35/45) all the way in with a couple of micro freeze ups. Then I got over the numbers and the VRAM jumped from 3.4 to 6.8 and the sim froze completely and did not recover. My textures were set to 1024 as well.

Are the retainer walls suppose to be there even though the slope is gone, looks very strange. Also the ILS appears to be aligned with the slope as I was way high. Maybe you should try and make another version w/o the wall and slope.

And the KFLL exclude that goes in the KMIA scenery. When it is installed FLL buildings are gone.

Other than that I took a PMDG 747 off the runway at MIA at 44fps with no stutters, MSY with the PMDG 738 at 54fps no stutters and SCEL with the PMDG 748 at 55fps and absolutely smooth like it was when I use to ride jumpseat.

You should consider putting me on your BETA team, these are the kinds of reports you would receive. I am on the PMDG BETA and have done scenery beta for Flightbeam, DD, and Flytampa. I am available.

Randy

[RicardoLVFR]

Ricardo.

Excluded the slope flew in with the FSLabs 320. FPS was fine (35/45) all the way in with a couple of micro freeze ups. Then I got over the numbers and the VRAM jumped from 3.4 to 6.8 and the sim froze completely and did not recover. My textures were set to 1024 as well.

Are the retainer walls suppose to be there even though the slope is gone, looks very strange. Also the ILS appears to be aligned with the slope as I was way high. Maybe you should try and make another version w/o the wall and slope.

And the KFLL exclude that goes in the KMIA scenery. When it is installed FLL buildings are gone.

Other than that I took a PMDG 747 off the runway at MIA at 44fps with no stutters, MSY with the PMDG 738 at 54fps no stutters and SCEL with the PMDG 748 at 55fps and absolutely smooth like it was when I use to ride jumpseat.

You should consider putting me on your BETA team, these are the kinds of reports you would receive. I am on the PMDG BETA and have done scenery beta for Flightbeam, DD, and Flytampa. I am available.

Randy

Hi, there must be something else at play here. Do you want to try the non-PBR versio of KFLL?

[rsmith6621ab]

That would be great.

[rsmith6621ab]

Also I purchased my copy of KFLL on May 4th. Do I need to apply the HotFixes that are in the upgrade and patch forum?

[RicardoLVFR]

hi, please email us and we will send you a link of the non-PBR version. its support(at)latinvfr.com