KMIA defaut runway textures shimmering through (RESOLVED)

[Mobu86]

Hi!

Just purchased and installed your KMIA scenery into a freshly installed P3D V5 and I am experiencing Problems with the runway textures. the orignal ones are shimmering through in different angles (not in all).

How can I solve this issue?

Rgds
Moritz

[RicardoLVFR]

Hi, what do you mean shimmering? can I see a picture. And if you installed SODE 1.7 please make sure you install the recently released SODE hotfix for KMIA.

[Mobu86]

Hello Ricardo,

Please see attached picture. The runway is flooded with water and there is a an “overlap” respectively the default runway temporarily seems to be on top of the Latin one.

I have not installed the hotfix yet. This might solve the problem. I cancelled the installation of the update because I could only install the hotfix into C:? At least this is the path automatically selected for this update. My sim and your scenery is located in F:. So I was unsure if the installation will be successfully completed...

Thanks for your swift response!

Rgds
Moritz

[RicardoLVFR]

Hello Ricardo,

Please see attached picture. The runway is flooded with water and there is a an “overlap” respectively the default runway temporarily seems to be on top of the Latin one.

I have not installed the hotfix yet. This might solve the problem. I cancelled the installation of the update because I could only install the hotfix into C:? At least this is the path automatically selected for this update. My sim and your scenery is located in F:. So I was unsure if the installation will be successfully completed...

Thanks for your swift response!

Rgds
Moritz

Yes it seems you installed SODE 1.7, you need to install the hotfix, it will install wherever you got SODE installed, so don't worry on which drive it is.

[Mobu86]

The Hotfix solved the issue!

[sticky1202]

Ran the hotfix, but it did not fix the shimmering/wet ground effect.

Jim

[sticky1202]

Just went back to previous SODE 1.6.8 (I think) and all is fine...

Jim