1st flight after update

[Aceituno]

Hi,

I’m flying to try the new update.

I’m at FL410 right now and A/THR active but auto speed is requesting 285 knots (red zone, overspeed).

I set the speed at 250 knots and all is ok.

There is also a little issue remaining. On Xbox the throttle pass from idle to full reserve, is not proportional.

Edit: Successful flight, in the pic I’m just arrived to London.



Please, fix the steering wheel and the red strip for landing!

I write this to help to improve the plane.

Also, the pfd brightness has been improved.

Thanks to all LVFR team, I’m sure this will be a great plane!!

Best regards!

[RicardoLVFR]

Strange, if in managed mode it should be .82 mach, this can happen if you switch from mach to speed.

[Aceituno]

Strange, if in managed mode it should be .82 mach, this can happen if you switch from mach to speed.

You’re right Ricardo. I switched from mach to knots.

I didn’t know this can happen!!

Switched again to Mach and all is ok!

Thanks!!