LEMD Runway Operation (resolved)

[ScottecLEMD]

Hi Ricardo,

Been away for a few days but now I have loaded up my sim. Runways in use are 36L/R for departure and 32L/R for landing. Just observed an easyJet A319 EZY7613 landing on Runway 36L. You can also see on my UTL status board an AEA6024 arriving runway 18L

Metar - LEMD 071500Z VRB02KT CAVOK 13/M00 Q1030 NOSIG

It seems to be an issue with light and variable winds, which have been persistent here since before Christmas.

Regards,

Ken

[RicardoLVFR]

Hi, you don't have any residual LEMD files from other scenery? because for certain its working for all of us, just did some tests and had others test as well. Let me know

[ScottecLEMD]

Hi Ricardo,

No other files, this was a clean install of Windows, P3D and LEMD - all drives were formatted. The only other scenery is the default P3D and Orbx LC Europe.

[RicardoLVFR]

Hi, can you send me via email to support(at)latinvfr.com the file: LEMD_ADEP4_LVFR.bgl

I want to check it.

[ScottecLEMD]

Hi Ricardo,

E,mail sent with the attached file as requested. Apologies for the delay.
Un Saludo,
Ken

[ScottecLEMD]

Hi Ricardo,

Further to this, I had aircraft cleared to land on RWY 14L on Sunday. Winds were again light and variable.

Saludos,

Ken

[RicardoLVFR]

Hi, we responded to your email.

[ScottecLEMD]

Hi Ricardo,

I think I finally figured out the issue. I always install my addon scenery out with the P3D directory, LEMD included. However after doing a clean install again I allowed the installer to use the default paths.....hey presto....now I have correct runway operation. I don`t know why that should make a difference but it has. Maybe you can figure that one out!

Un saludo.

Ken

[ScottecLEMD]

I spoke to soon. Still an issue but more obvious when there is a light and variable wind.

One other thing to note. If I take off RWY´s 36L or 36R and request a circuit, I am instructed by ATC to land on RWPY 36L or 36R, not 14L or 14R.

Saludos,

Ken

[RicardoLVFR]

Hello Ken,
I just recently installed P3dv4.5 on a system, I decided to give it a quick run on LEMD and had no issues.

I suggest you uninstall P3dv4 and re-install new completely the full installer. let me know