LatinVFR forums

I have a honeycomb bravo throttle but it is not possible to calibrate it and the default notches do not return, how can I do it?

Hi,

I have the Bravo throttles also. And they work properly without any need for calibration. Im not sure what you mean by the notches do not return?
Moving the throttle over them does move them into the notch detent.

I have a honeycomb bravo as well with inserts that make the detents for the TOGA, Flex, and CLB settings. Not sure if this is what OP has but without the ability to calibrate the throttle, these detents are out of position.

The plane was just released is a question of time and these things will be figured out

for good luck I purchased the airbus kit created in 3d with the various climb, flex, toga notches and unfortunately they don't match but if it will be fixed over time then it's fine