Page 1 of 1
DGXI error at KMSY
Posted: Mon May 18, 2020 2:56 pm
by jay4421
I don't know if it is an issue on your end or Lockheed's end, but every time I am at KMSY I am getting a DGXI error, right when I start up or at the airport for 1 min.
Re: DGXI error at KMSY
Posted: Mon May 18, 2020 7:02 pm
by RicardoLVFR
hi, what exactly does the error say?
Re: DGXI error at KMSY
Posted: Fri Jul 24, 2020 7:18 pm
by ScottSimmons
I'm getting the same error at KMSY.
System Config:
P3Dv5 5.0.31.35253, nVidia driver v451.77
i7-4790K, 16GB RAM, P3D installed on dedicated SSD (F:\)
Windows 10, v2004, build 19041.388
First CTD was on descent from the north a few miles before I was going to turn downwind (west) for Rwy 11
I recovered the flight from an FSUIPC save.
I was on a 10 mile final for Rwy 11 when it happened again. I recovered again, and the error appeared within 30 seconds.
"This device (NVIDIA GeForce RTC 2080 Ti) stopped working for the following reason:
DXGI_ERROR_DRIVER_INTERNAL_ERROR. Do you want to exit Prepar3d? Click Yest to exit, No to disable rendering to this device, or Cancel to keep using this device (Prepar3D may crash).
The error message is accurate.
If I click 'Cancel' the error message re-appears.
The 2nd time I click 'Cancel' P3Dv5 immediately CTDs (crashes to desktop).
I disabled KMSY in the P3D Add-on page, recovered the flight again and landed with no error with the default scenery.
Re: DGXI error at KMSY
Posted: Fri Jul 24, 2020 8:16 pm
by RicardoLVFR
hi, have you tried reducing your scenery display settings?