Page 1 of 1
No Jetways only Stubs at KMIA
Posted: Sun Sep 12, 2021 2:56 pm
by IanHarr
P3d v5 (5.2.22.27615). GSX, KMIA v5.1 non PBR. SODE installed.
Everything downloaded fresh but there are only "stumps" where the Jetways should be. If I tell GSX to install a Jetway, it does not attach itself to anything but sits away from the building.
What must I do?
Re: No Jetways only Stubs at KMIA
Posted: Sun Sep 12, 2021 7:00 pm
by RicardoLVFR
can we see a picture please?
Re: No Jetways only Stubs at KMIA
Posted: Mon Sep 13, 2021 5:17 am
by IanHarr
Picture 1 is stock as it shows when first loaded.
Picture 2 is after asking GSX to add a jetway. Gate is KMIA D28.
Re: No Jetways only Stubs at KMIA
Posted: Mon Sep 13, 2021 1:45 pm
by RicardoLVFR
hi, sorry but can't see the pictures.
Re: No Jetways only Stubs at KMIA
Posted: Mon Sep 13, 2021 2:32 pm
by IanHarr
This is hopeless.
The message system says the file is too large.
When I sent it before it was shrunk to 50% and was accepted.
It is in standard jpeg/Paint format, so I don't understand how you did not see it.
Let's just forget it and I will just use buses at Miami and forget about Jetways.
Re: No Jetways only Stubs at KMIA
Posted: Mon Sep 13, 2021 4:05 pm
by RicardoLVFR
can you send me the pictures to
support@latinvfr.com please